Simons Voss Technologies Palm LDB Version 1.40 Manual de Instalação descarregar pdf (Página 177)

Smart Output Module

Page 6

4.0 Before Installation

 Unpack the Smart Output Module and inspect it for external damages.

 Connect the Smart Output Module to a type SREL.ADV Smart Relay (see

Connection to the Smart Relay) and provide both units with voltage over the

power supply.

 Note the polarity.

 Activate the Smart Relay with a transponder in the condition as received from

the factory. This activates all Smart Output Module outputs, which is shown by

all LED’s on the Smart Output Module lighting (green).

5.0 Installation

 Cut the DIN rails to size and tighten the screws.

 Switch off the supply voltage.

 Mount the units on the DIN rail (latch).

 Connect all cables (see Terminal Assignments and Connection Examples).

 Be sure to pay attention to the polarity when connecting the supply voltage.

 Switch on the supply voltage.

 Program the Smart Relay and the Smart Output Module with the SimonsVoss

software (see Programming and Configuration).

 Then test the function with authorised transponders.

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 317 318

Sem comentários

Simons Voss Technologies Palm LDB Version 1.40 Manual de Instalação Página 177